I am Bruno De Michelis. Since three years ago I have started to be interested in multirotors for videwography and began designing, building and flying my own craft. I prefer to manually fly my craft and avoid automatisms.
My original quadcopters and some of my hexacopters use the CC3D. I am adding a few photos of them.
I have one question: IS IT POSSIBLE TO CONFIGURE A CC3D FOR A "V" HEXACOPTER? At present I have it configured for an "H" type. It works reasonably well on a V hexacopter, BUT I am getting a few lateral oscillations while descending (loosing altitude to land).
IS THERE ANYTHING I CAN DO TO RECTIFY THIS SITUATION? IS IT A MATTER OF RECONFIGURING THE PDIs AND IF SO, HOW? Any advice or solution will be really appreciated. I thank you all in advance.