i am building my first quad. So i am completly new at that.
My frame is a selfprinted clone of the crossfire 2 could be found on thingiverse and i am using the instructions from that project.
But i changed a view components that are used in this project. So i am not going to use a AMP 2.6 for it. I decieded to use a Sparky 2.0 with tau labs. Also i use other motors, sunnysky X3108S KV900 with APC 10x4,7 SlowFlyer.
My LiPo is 4s 7000 25/40c instead of the 5000 wich is smaller so i was used to improve my stands with additional Bumber (found on thingiverse) made of Flexfilament wich hopefully also helps me to get smother landings.
My remote is a turnigy 9xr Pro with a frsky XJT modul and a frsky x8r receiver and frsky Telemetry extend cable.
I use RCTimer 30A OPTO Brushless ESC and a uBEC 5v 3A to power up the sparky2.
I try to use SBus for Telemtry using the inverter cable based on a IC.
For SAT-Navigation i use a NEO-M8N with mag
Most Parts allready arrived. Still waiting for the uBec and NEO-M8N
- Frame is printed and mounted
- Motors, ESC, Powerdistribution are mounted and wired
- GSC is installed on OSX
- Sparky 2.0 is updated and working with the GSC
So i am happy to be part of the community right now
Greatings from Germany,