Running TauLabs software on hardware that isn't supported? Work with others to get a new platform supported.
no avatar
User

davidlyw89

Posts

1

Joined

Tue Jun 07, 2016 4:40 pm

Sparky v2 only recognize by computer in DFU mode

by davidlyw89 » Tue Jun 07, 2016 5:02 pm

earlier I flash raceflight using dfuse and it work properly. After that I trying to reflash raceflight and it started have this problem. Im still using the same method dfuse to flash raceflight. However, after finished upgrade, and replug - in USB, it just have the constant green led, and com port doesn't show anything, until i shorted SBL and it still in DFU.
Any idea how could i solve this problem? thanks
no avatar
User

pug398

Posts

700

Joined

Fri Mar 07, 2014 2:26 am

Re: Sparky v2 only recognize by computer in DFU mode

by pug398 » Thu Jun 09, 2016 10:14 pm

I would try to get it back to a working condition before flashing raceflight (which I know nothing about). In the firmware folder each target has a ef_target.bin. Using dfu mode flash this file to the target and it should write the firmware bootloader and flightware all at same time. Remove dfu mode SBL jumper and reboot and the board should boot up and be able to connect to Talulabs again. I guess then you can try the raceflight thing again.

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB ® | phpBB3 Style by KomiDesign
cron