For discussion on any the supported hardware platforms, such as TauLabs, Quantec, OpenPilot or the STMicro Discovery platforms.

OpenLRS with CC3D revo

no avatar





Sun May 22, 2016 4:46 am

OpenLRS with CC3D revo

by scottadams » Sun May 22, 2016 5:01 am

I have a CC3D revo flashed with the latest minirevo tau labs firmare,
i have a orange lrs tx module that has the latest (3.8.8) version of the openLRSng firmware.

the lrs system works i used to use it with an orange lrs receiver.

I have read that you can remove the lrs receiver and use teh revo's inbuilt radio, this is my primary reason for switching to tau labs.

i have removed telemetry from the openlrs tx config (in fact ive cleared the eprom and reflashed the orange tx module then dissabled telemetry.

i have followed the guide here ... e:-OpenLRS

but i cannot get it to bind, is there anythign more that i may be mssing here, i have limited the ppm stream to 8 channels as well.

is there anyway that i can tell that the revos radio is in bind mode? i never see any lights flashing quickly,

do i need to flash the radio seperatly? if so how can i do that?

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB ® | phpBB3 Style by KomiDesign