Discussion about development tools and environments, such as STLink, OpenOCD, arm-gcc, Eclipse, Qt Creator and Visual Studio.

STM32F3-Discovery Board

no avatar
User

Eikasis

Posts

1

Joined

Sat Dec 26, 2015 4:05 pm

STM32F3-Discovery Board

by Eikasis » Sat Dec 26, 2015 4:21 pm

Hi , merry christmas!

I have a STM32F3-Discovery Board, with STM32 ST-LINK Utility I have programmed the bootloader bl_flyingf3.bin from the taulabs_next_20151114_062639_5768191cf5_win32. In Taulabs GCS 20151123 I have flashed the flyingf3 firmware from the firmware folder.

When I finished the process, the program not recognise the board. Is necessary to enter in rescue mode. When I enter in rescue mode, Flyingf3 with the firmware are detected.
I think that is a comunication problem because USB TX is Ok but RX not.

If I make the same process with the CC3D firmware it works fine. Hope anybody can help me.

Thanks a lot!
no avatar
User

ernieift

Posts

193

Joined

Sun Mar 02, 2014 11:21 am

Re: STM32F3-Discovery Board

by ernieift » Sun Dec 27, 2015 8:59 am

Just tried it again. Works flawless. My Tips: check all jumpers (https://github.com/TauLabs/TauLabs/wiki/Creating-a-FlyingF3-from-scratch). In rescue, flash the fw_flyingf3.tlfw and start with safe boot. Now select erase all settings from menu, cycle power and configure from ground up.

Hope it helps. and merry christmas...

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB ® | phpBB3 Style by KomiDesign
cron