Post here for help with your new vehicles setup. Friendly advice on tuning and settings.
no avatar





Fri Aug 19, 2016 9:36 pm

HELP!!! Brushed sparky cannot bind to openlrs tx

by sogun3 » Fri Aug 19, 2016 10:21 pm

I recently acquired a brushed sparky 2 and a hawkeye UHF RC system that attaches to taranis X9D. I followed every step on the github ( to the point, as well as the video -- except i didn't have a camera so i didn't solder the camera on.

However, when I tried to bind the transmitter to the brushed sparky, it didn't work for 15 minutes straight. Did I do anything wrong? soldered anything wrong? Do I need to do something to the hawkeye module before trying to bind the brushed sparky to the transmitter? Thanks a lot for the help!

back side of brushed sparky
Capture.PNG (590.13 KiB) Viewed 4106 times

front side of brushed sparky
Capture_1.PNG (563.27 KiB) Viewed 4106 times

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB ® | phpBB3 Style by KomiDesign