Chat about quadcopters, tricopters, hexacopters or your decacopter.

arming settings?

no avatar
User

5PAZT1C

Posts

1

Joined

Fri Dec 18, 2015 3:16 am

arming settings?

by 5PAZT1C » Fri Dec 18, 2015 3:23 am

I'm running a cc3d board with an Frsky Taranis Plus. the GCS recognizes the switch i want to use as an arming switch, and it;s even labeled arming switch in GCS, but when I go to arming tab and set "switch plus throttle" to arm, and after saving it, I cant get the darned thing to arm.

any cclue whats going on?
no avatar
User

zalex820

Posts

2

Joined

Thu May 12, 2016 2:53 am

Re: arming settings?

by zalex820 » Thu May 12, 2016 3:09 am

Make sure the throttle min is calibrated and use SWITCH-THROTTLE-DELAY setting. Also make sure arming is set to the correct channel in RC INPUT.

Screen Shot 2016-05-11 at 11.08.33 PM.png
Screen Shot 2016-05-11 at 11.08.33 PM.png (97.54 KiB) Viewed 5343 times

Who is online

Users browsing this forum: No registered users and 1 guest

Powered by phpBB ® | phpBB3 Style by KomiDesign
cron